Hi,
I followed all the steps in order to build the CNC... it works very well but I have a problem with the Z-axis setup... when I mill it don't respect the correct depth that I have wrote in the software (Estlcam V11)... could you help me please?... I looked into the firmware but I didn't find any Z setup for the screw steps or other... In the site I saw different ways to resolve the problem but I don't have any of thoose devices and I'm not a programmer...so could u help me with this step by step?
Thank you.
Ory
CNC RS-CNC32 Z setup
Re: CNC RS-CNC32 Z setup
Hi Ory,
Without milling, does the Z axis move coorectly? Regarding to this page, does the axis move to the desired distance ? If not, the lead of your ACME TR8 threaded rod is surely not 2mm. The best solution is to change your ACME TR8 threaded rod for the right one.
See ya,
Without milling, does the Z axis move coorectly? Regarding to this page, does the axis move to the desired distance ? If not, the lead of your ACME TR8 threaded rod is surely not 2mm. The best solution is to change your ACME TR8 threaded rod for the right one.
See ya,
Gilles, aéromodéliste (RC aeromodeller)
Contributions sur thingiverse (contributions on thingiverse)
Assembly manual of the RS-CNC32
Service de dépannage / Troubleshooting service
Contributions sur thingiverse (contributions on thingiverse)
Assembly manual of the RS-CNC32
Service de dépannage / Troubleshooting service