Note: This version has been replaced by the RS-CNC32
Fully Autonomous and very easy to use, it just needs to be plugged into an outlet:
-Place it at the desired location
-Connect the plug
-Fix the milling stock
–Set the router bit manually to the point of origin with the adjustment wheels
-Insert the SD card containing the g-code
-Start the program via the LCD
It also has 4 rubber pads at each angle, anti-vibration and anti scratch.
The electronics are integrated into the machine and it has a front USB port to connect a computer to the Ramps 1.4 if necessary without dismantling everything.
Clean installation thanks to dragchains
The pressure of all bearings on the square tubes is fully adjustable
Very high torque for Y moving thanks to a nema motor 23 multiplied by 3 with pulley 20×60 teeth
Integrated LED lighting
Easy mounting with printable drilling templates
Go to the parts list !