Max accel/feed for hardware

[spons]

Hi,

Have anyone tested RS-CNC32 hardware capabilities in terms of speed and accel to use with laser? I mean, what are the highest values so that hardware (belts, 3d prints etc) will handle without too much steress? The design is rather not intended to be used with high accel rates but I bet somebody has already pushed it to the limits

[peakbag]

Hi,

Have anyone tested RS-CNC32 hardware capabilities in terms of speed and accel to use with laser? I mean, what are the highest values so that hardware (belts, 3d prints etc) will handle without too much steress? The design is rather not intended to be used with high accel rates but I bet somebody has alreadygeometry dash world pushed it to the limits

I haven't tried it but could these be two incompatible devices?