Z axis problem
Posté : 13 juin 2021 21:04
Hello,
I have 3 identical motors, when I move the X and Y axis it moves by the correct dimension which is shown on the LCD.
When I move the Z axis, 3mm of the movement is 6mm on the lcd, where's the problem?
As a result, I cannot set the Z cut level
B/r
Maciej
I have 3 identical motors, when I move the X and Y axis it moves by the correct dimension which is shown on the LCD.
When I move the Z axis, 3mm of the movement is 6mm on the lcd, where's the problem?
As a result, I cannot set the Z cut level
B/r
Maciej