Z axis problem

[kulfon250]

Hello,

I have 3 identical motors, when I move the X and Y axis it moves by the correct dimension which is shown on the LCD.
When I move the Z axis, 3mm of the movement is 6mm on the lcd, where's the problem?

As a result, I cannot set the Z cut level

B/r
Maciej

[HTheatre]

Hi Maciej,

Was the first time you started your RS-CNC32?
Please, post a picture of the table printed on your drivers and another one of the microswitches' config of the Z-axis' driver.

See ya,

[kulfon250]

Hello,
Thx for help.
I found the cause of the problem, for some reason, despite 3 identical motors.
I had to make different settings for the Z axis motor in TB6600.

[HTheatre]

Hi Maciej,

I had to make different settings for the Z axis motor in TB6600.

Exactly ! That's why I had asked you to post pictures of the Z-driver.
I am glad to read all woring fine for you now.

See ya,