Hi ,
I have to question regarding this peace.
Should I print this in petg instead of PLA , I am quite worried about temperatures the mill can raeach.
Also , one part of the holder is connected , should I cut it? (look at the picture)
thx
Andrea
Router-65.stl some questions.
Router-65.stl some questions.
Vous n’avez pas les permissions nécessaires pour voir les fichiers joints à ce message.
- Patient0x00
- Messages : 72
- Enregistré le : 08 oct. 2018 03:00
Re: Router-65.stl some questions.
I have printed it in PLA and I everything is working fine for me but I have not had long cuts so far.
I also cut the tab otherwise it would not hold the router in place.
Frederik
Sent from my iPhone using Tapatalk
I also cut the tab otherwise it would not hold the router in place.
Frederik
Sent from my iPhone using Tapatalk
- RoMaker
- Administrateur du site
- Messages : 5063
- Enregistré le : 02 janv. 2017 20:24
- Localisation : Montpellier
- Contact :
Re: Router-65.stl some questions.
Hi !
Yes, this part have to be cut, but should be at the bottom to be printed.
Yes, this part have to be cut, but should be at the bottom to be printed.
Re: Router-65.stl some questions.
thx, Yes I already printedit I misplaced on the bad only for let you see it better.
thank you very much for you help.
I am having a lot of fun building it!
thank you very much for you help.
I am having a lot of fun building it!
Modifié en dernier par Claustro le 03 nov. 2018 19:34, modifié 1 fois.
- RoMaker
- Administrateur du site
- Messages : 5063
- Enregistré le : 02 janv. 2017 20:24
- Localisation : Montpellier
- Contact :
Re: Router-65.stl some questions.
No, i never had problems with PLA parts
Re: Router-65.stl some questions.
I edited my previous post because I didn't read the previous message But I did it too late
thank you again!
thank you again!