Hi,
Is there any plan to make a 4th axis upgrade to the R/RS-CNC?
Adding 4th axis to R-CNC?
- RoMaker
- Administrateur du site
- Messages : 5064
- Enregistré le : 02 janv. 2017 20:24
- Localisation : Montpellier
- Contact :
Re: Adding 4th axis to R-CNC?
Hi 3Dstyle !
The shield allows to add a 4th axis, but i never tried.
And the original Z heigth is very limited to add a 4th axis without mechanical mods.
Cheers
Romain
The shield allows to add a 4th axis, but i never tried.
And the original Z heigth is very limited to add a 4th axis without mechanical mods.
Cheers
Romain
Re: Adding 4th axis to R-CNC?
maybe this could be a good start for small works on a 4th axis....
https://www.ebay.com/itm/Rino-Motorized ... ctupt=true
https://www.ebay.com/itm/Rino-Motorized ... ctupt=true