dead ramps 1.4 ?

Répondre
fullspeed1236
Messages : 16
Enregistré le : 02 févr. 2018 23:14

dead ramps 1.4 ?

Message par fullspeed1236 »

finnaly my R-CNC work fine.. But I want endstops and for sure I wiring on 2 wrong pin (+-). now my LCD is dead and nothong work.. question... wich board is faulty?..

BR
Sebastjan
Avatar du membre
RoMaker
Administrateur du site
Messages : 5063
Enregistré le : 02 janv. 2017 20:24
Localisation : Montpellier
Contact :

Re: dead ramps 1.4 ?

Message par RoMaker »

Hello Sebastjan !

You have wired the endstop between + and - ? If it's the case you do a short circuit :(
You should connect the endstop between - and S pin (signal)

Image
fullspeed1236
Messages : 16
Enregistré le : 02 févr. 2018 23:14

Re: dead ramps 1.4 ?

Message par fullspeed1236 »

Yes... shot citrcut.. I try and stop only in one direction, then I swich betven + and - and dead.. Wich board is now faulty? uper one or mega 2560?
Avatar du membre
RoMaker
Administrateur du site
Messages : 5063
Enregistré le : 02 janv. 2017 20:24
Localisation : Montpellier
Contact :

Re: dead ramps 1.4 ?

Message par RoMaker »

it's hard to say but I think the mega 2560 5v regulator burned
Rochdaleblue
Messages : 26
Enregistré le : 18 mars 2018 11:54

dead ramps 1.4 ?

Message par Rochdaleblue »

.
Rochdaleblue
Messages : 26
Enregistré le : 18 mars 2018 11:54

Re: dead ramps 1.4 ?

Message par Rochdaleblue »

fullspeed1236 a écrit :finnaly my R-CNC work fine.. But I want endstops and for sure I wiring on 2 wrong pin (+-). now my LCD is dead and nothong work.. question... wich board is faulty?..

BR
Sebastjan
Hi Sabastjan

Hope you dont mind me contacting you but did you manage to get the endstops sorted and if you did can i ask :=

1 what type of endstops did you use
2 where did you place them
3 where did you finally wire them too and did you need any extra software.

Thanks in advance.

Tony


Sent from my iPad using Tapatalk


Sent from my iPad using Tapatalk
Répondre