Ramps LCD always on?

Répondre
Remo400
Messages : 10
Enregistré le : 16 janv. 2018 09:41

Ramps LCD always on?

Message par Remo400 »

Hello,
I am about to finish my I3-R 3D Printer. What confuses me is that the Ramps/Arduino is still on when i switch the Powersupply off. As long as the computer is on the Arduino is on.
Is it that it gets the power from the PSU and the USB in paralell?

regards
Ernst
Avatar du membre
RoMaker
Administrateur du site
Messages : 5068
Enregistré le : 02 janv. 2017 20:24
Localisation : Montpellier
Contact :

Re: Ramps LCD always on?

Message par RoMaker »

Hi Ernst !
Yes it's normal, as long as the ramp is powered by the USB, it stays on !
The only solution is to unplug the USB port !
Romain
Répondre