9.Locked (alarm or jog)

[kulfon250wr]

1.I get this error every time I run it. Unlocking it requires moving the axis forward/back three times and then the padlock unlocks it. What could it be? I didn't have this in firmware 1, now in 2.1 every time.
2. In firmware 1, after starting the engines were not blocked, the head could be moved. Unfortunately, in 2.1 it is not possible to do it manually, is it on purpose or is something wrong with me?

[rominetb44]

Hi kulfon250wr,

The message "Cmd JOG:missing OK" means there is no answer received from GRBL within 500msec for Jog command (moving with nunchuck or with arrow in Auto mode).
This is probably a consequence of an error in GRBL.
Could you give us the answer to the command "?" when GRBL is Locked ?

Thanks

[kulfon250wr]

The nunchuk is connected and after manual unlocking it works normally.
Clean software 2.1 is installed, without any changes.
I don't really know how to check the "?" command. Can you explain what to do, I'm not an IT specialist.

[rominetb44]

Hi kulfon250wr,

Could you confirm that u are using GRBL board V1.0/1.5 and not GRBL board V2.0 ?

2. In firmware 1, after starting the engines were not blocked, the head could be moved. Unfortunately, in 2.1 it is not possible to do it manually, is it on purpose or is something wrong with me?

This is a parameter of GRBL that you can set with the $1=255 command.
Did you make any change in GRBL configuration ?
Did you use a software to connect a PC to GRBL lately ?

See u

[kulfon250wr]

Hey,
Yes I used GRBL board V2.0.

Did you make any change in GRBL configuration ?
No

Did you use a software to connect a PC to GRBL lately ?
Yes, but nothing change

[kulfon250wr]

Ok, sorry, I mixed up threads, this is thread 1/1.5, can it be moved?

[rominetb44]

Hi kulfon250wr,

Hey,
Yes I used GRBL board V2.0.

So you can check the status of GRBL with WebUI.
In WebUI you can send the command "?" in the window Commands and post the answer.
You can so check the value of $1 by sending "$1" command.

commands.png

Otherwise you can send all this commands with a software as LightBurn, LaserGRBL, Estlcam, ...

Did you make any change in GRBL configuration ?
No

Did you use a software to connect a PC to GRBL lately ?
Yes, but nothing change

Be careful, you have to unplug the screen board when connecting a PC to the ESP of the GRBL board (same serial port).
Which software are u using ?

See U

[kulfon250wr]

I had $1=255, I set $1=0 and now after turning on the stepp engines are turned off

[rominetb44]

I had $1=255, I set $1=0 and now after turning on the stepp engines are turned off

Hi kulfon250wr,

Sorry, I made a mistake, you'are right for unlocking the motor the value of $1 shouldn't be 255.
Good job !
Do you still get an alarm ?

See you

[kulfon250wr]

The alarms are still there as in the photos and I have to manually unclick them