![Sourire :)](./images/smilies/icon_e_smile.gif)
John,
I found a couple of nice clamp parts
And printable parallels, v blocks etc up Thingiverse.
Your braver than I am to use a metal clamp for close in machining. When I learn milling back in the 70’s there was no plastic or 3dprinters so metal
it was. There are also printable screws and other keep it from flying pieces parts. Plastic kind of takes the fun out of the shrapnel of a blown bit...
Heading out to the shop after work tomorrow to finish mechanical for the gantry. Not enough hours in the day.