Hello,
does anyone of you connected successfully the CNC via USB with Estlcam?
Is it possible to control the CNC with Estlcam?
Connecting Estlcam to RS-CNC32?
Re: Connecting Estlcam to RS-CNC32?
Hi Kraut,
I changed to Estlcam.
But installed a simple Arduino Uno instead of the original elektronics. Very cheap and easy to do!
You find the installation pattern in Estlcam.
It works perfect! Installation takes a few seconds.
Imo Estlcam is a very good alternative for beginners. It takes about one hour and you are in it.
Greets Martin
I changed to Estlcam.
But installed a simple Arduino Uno instead of the original elektronics. Very cheap and easy to do!
You find the installation pattern in Estlcam.
It works perfect! Installation takes a few seconds.
Imo Estlcam is a very good alternative for beginners. It takes about one hour and you are in it.
Greets Martin
Vous n’avez pas les permissions nécessaires pour voir les fichiers joints à ce message.
Re: Connecting Estlcam to RS-CNC32?
Thanks for you reply Martin!
OK nice.
So Estlcam connected to the origin hardware does not work?
It's a little bit sad if I change the hardware to Arduino I will loose the touch screen option.
Regards
Kraut
OK nice.
So Estlcam connected to the origin hardware does not work?
It's a little bit sad if I change the hardware to Arduino I will loose the touch screen option.
Regards
Kraut