MeshCAM
-
- Messages : 14
- Enregistré le : 06 avr. 2020 15:40
MeshCAM
Anyone ever used MeshCAM with the RS-CNC? I've used it with other CNCs without issue, but I'm struggling to find the right profile. There has to be at least 30 options, but most end with .NC which doesn't seem to show up on the TFT. I've found .GCD and .NGD seem to work, but best I've been able to do so far is plunge.
Vous n’avez pas les permissions nécessaires pour voir les fichiers joints à ce message.
- RoMaker
- Administrateur du site
- Messages : 5063
- Enregistré le : 02 janv. 2017 20:24
- Localisation : Montpellier
- Contact :
Re: MeshCAM
Hi, Is it for shield + Mega2560 or GRBL32bit board ?
-
- Messages : 14
- Enregistré le : 06 avr. 2020 15:40
Re: MeshCAM
Shield + Mega2560.
I ordered all my parts right before the RS-CNC32 came out, and then had a kid which put everything on hold
I ordered all my parts right before the RS-CNC32 came out, and then had a kid which put everything on hold