Router-65.stl some questions.

[Claustro]

Hi ,
I have to question regarding this peace.
Should I print this in petg instead of PLA , I am quite worried about temperatures the mill can raeach.
Also , one part of the holder is connected , should I cut it? (look at the picture)
thx
Andrea

[Patient0x00]

I have printed it in PLA and I everything is working fine for me but I have not had long cuts so far.

I also cut the tab otherwise it would not hold the router in place.

Frederik


Sent from my iPhone using Tapatalk

[RoMaker]

Hi !
Yes, this part have to be cut, but should be at the bottom to be printed.

[Claustro]

thx, Yes I already printedit I misplaced on the bad only for let you see it better.
thank you very much for you help.
I am having a lot of fun building it!

[RoMaker]

No, i never had problems with PLA parts

[Claustro]

I edited my previous post because I didn't read the previous message But I did it too late
thank you again!