Apologies if this has already been asked, but is there a probe port on the Shield board that can be used?
Many thanks
Probe port
-
RoMaker
- Administrateur du site
- Messages : 5063
- Enregistré le : 02 janv. 2017 20:24
- Localisation : Montpellier
- Contact :
Re: Probe port
Hi,
Yes, it's "Z-" but the firmware is not already set for this function, i have to see that...
Yes, it's "Z-" but the firmware is not already set for this function, i have to see that...
-
Patient0x00
- Messages : 72
- Enregistré le : 08 oct. 2018 03:00
Probe port
Romain,
Have you considered the use of Grbl instead of repetier?
It has the support for g38 (z probe) and g54-g59, which makes the use of a z probe more friendly.
I think it would also allow the use Mach-3/4 type of software but I’m not sure of that last point.
Frederik
Sent from my iPhone using Tapatalk
Have you considered the use of Grbl instead of repetier?
It has the support for g38 (z probe) and g54-g59, which makes the use of a z probe more friendly.
I think it would also allow the use Mach-3/4 type of software but I’m not sure of that last point.
Frederik
Sent from my iPhone using Tapatalk