Directions of axes

Répondre
xaocass
Messages : 25
Enregistré le : 28 déc. 2017 19:57

Directions of axes

Message par xaocass »

I think it would be very useful to add a picture with drawn axes and their directions to instructions page.

Today I've started testing my cnc. I've made a word in Fusion 360, ran it via repetier, but it was drawn flipped on the X axis. Now I'm not sure if it's my marlin config or have I done something wrong in the software?

PS. BTW my r-cnc is without X belt update.
Avatar du membre
RoMaker
Administrateur du site
Messages : 5063
Enregistré le : 02 janv. 2017 20:24
Localisation : Montpellier
Contact :

Re: Directions of axes

Message par RoMaker »

Hi !

Have you tested your axes under repetier host as requested in the tutorial on "software" page?
We will now move the axes of our CNC! To do this, “Manual control” tab. But above all, manually position each axis in the middle of the travel.

You have 3 sets of buttons, the left control X and Y, the middle Z, and the right one the extruder.(But we do not need the latter in our case!)

Image

When you click down on the left button set, the portal (Y) must move frontward from the value in mm you have clicked and vice versa.
When you click to the right, the extruder (X) must go to the right of the value in mm that you clicked.
Same with Z on the middle button set

Note: If one of the motors does not rotate in the correct direction, simply turn its plug 180 ° on the Ramps 1.4 (for the nema 17) or by inverting the two pairs of wires of the nema 23 motors on the TB6600.
Romain
xaocass
Messages : 25
Enregistré le : 28 déc. 2017 19:57

Re: Directions of axes

Message par xaocass »

My Repetier-Host UI looks different :)

Image
Avatar du membre
RoMaker
Administrateur du site
Messages : 5063
Enregistré le : 02 janv. 2017 20:24
Localisation : Montpellier
Contact :

Re: Directions of axes

Message par RoMaker »

How ! where did you find this version ???
xaocass
Messages : 25
Enregistré le : 28 déc. 2017 19:57

Re: Directions of axes

Message par xaocass »

Maybe the difference is because I'm on a mac?
xaocass
Messages : 25
Enregistré le : 28 déc. 2017 19:57

Re: Directions of axes

Message par xaocass »

Here are my X and Y axes directions. Arrows show directions.
I think I should switch both X and Y directions?

Image
Aze
Messages : 1928
Enregistré le : 11 mars 2017 14:13

Re: Directions of axes

Message par Aze »

Just switch Y.
xaocass
Messages : 25
Enregistré le : 28 déc. 2017 19:57

Re: Directions of axes

Message par xaocass »

OK, thanks. I've changed Y direction and now it looks ok :)

Btw, I've shared pen holder I designed. I think it's very useful to test CNC before actually cutting something.
https://www.thingiverse.com/thing:2853152
Avatar du membre
RoMaker
Administrateur du site
Messages : 5063
Enregistré le : 02 janv. 2017 20:24
Localisation : Montpellier
Contact :

Re: Directions of axes

Message par RoMaker »

Thank you for sharing your pen holder ;)
Répondre