MakerFr.com

Good morning all. I apologise but I am not very good with a computer but I try. I have installed the v2 upgrade but my preferred program easel from inventables couldn't find it. I have reverted back to v1. 5 and easle has found my board again however, what do I need to do with the tft boards firmware as the screen is now just illuminated but not displaying anything. I can't seem to find the 1.5 version of firmware only the 2.0 version.

Should I use this version and within the perameter selection select version 1?
I have not tried this as I would like to be sure before I do damage.
Thanks