Reset ESP32 TFT

Messages : 23
Enregistré le : 21 août 2020 16:53

Reset ESP32 TFT

Message par salomon »

good morning everyone,
I am testing my cnc a little at a time but I am encountering some problems that I cannot solve.
a first problem concerns the fact that the settings are not always stored in eeprom. I often have to connect UGS and import the file saved on the PC to be saved on the card ....

second problem:
sometimes at Power-On the TFT module tries to switch on but resets immediately, then switches on and off again and continues like this. to solve I have to do a few times Power-Off and Power-On.

The same problem often (not always) occurs when I try to connect with UGS. The TFT resets.

Could anyone please give me some suggestions?
Thanks in advance