Modified milling templates X

Messages : 2
Enregistré le : 18 juin 2017 11:33

Modified milling templates X

Message par ewald »

I modified the two drilling templates for X and Z axis parts. Since I am most used to it, I used Sketchup.

Due to restrictions in this board, this post contains just the X files.

In both templates I did the following:

- added drilling diameter and tapping size within borders around same sizes, so all holes are labelled in-place
- put shallow plugs in the drilling holes with a very small hole, so you can use a center punch or similar to mark the positions
- since my 3d printer does not support the full 20cm needed, I made printable pdf files for paper output. Print the template, scale resolution
for correct measurements, reprint and stick the paper to the work piece.

Hope someone finds this useful :-)
Vous n’avez pas les permissions nécessaires pour voir les fichiers joints à ce message.
Avatar du membre
Messages : 25
Enregistré le : 10 août 2017 10:36

Re: Modified milling templates X

Message par Zapan999 »

un petit blog rapide sur divers bricolages et projets...: