MakerFr.com

Thanks Aze, I had seen that but it’s a good point and could be the cause of the alarm. I just wondered if there was any instructions for the calibration under the tools menu


Sent from my iPad using Tapatalk

I think I hadn’t gone through the calibration process for the probe properly. Is the anything written down on how to do that with the z probe? Many thanks


Sent from my iPad using Tapatalk

I would have to check. Are you using the latest version of the firmware? It is available here https://github.com/mstrens/grbl_controller_esp32 Thanks for the quick reply. Yes, I am, but trying a bit more I can see I had some alarms and I hadn’t realised that I can touch “alarm” to show more. I thin...

Hi,
Can anyone help on this. I managed to create a z probe button as described in the excellent instructions, but after completing the probe check the cancel button, or anything else won’t let me return to any other screen. Has anyone else found this?
Many thanks

Hi,
I hope Roman won’t mind me dropping this in, but I did post this earlier on the forum which maybe of interest, which shows how you can do it.

https://discuss.inventables.com/t/makit ... sion/13916

Regards

Steve H

It allows you to level the bed ensuring the router is equi distance from the bed in all places

That’s great. Glad I could help.


Sent from my iPad using Tapatalk

Not sure if this helps or not, but I find that if I press the reset button first, it always works correctly.


Sent from my iPad using Tapatalk

Hi Oli, I certainly agree with you that it’s a brilliant job. Mine is finished and being fully used. Can I just tell you what I did in response to your question 1. You are right that something like the Katsu router only accepts bits of the two sizes you mention. I wanted the range offered by the er1...

OK, that’s great. Thanks for your help again.

Steve


Sent from my iPad using Tapatalk