MakerFr.com

Thanks for the reply. The status on the tft is idle and the problem occurs suddenly but I noticed that this happens after a long use of the machine. I do not see any tft messages that suggest a communication error. Can it be a problem of overheating of the motors or the board?

I have read in other posts that the sudden problem of the engines during work could be caused by a communication error between the esp32 and stm32 and that this problem could be solved with shielded cables. What do you think?

thanks for the answers guys, if I can I will make a video and some photos to make the idea. for the construction I used aluminum profiles and the machine seems very resistant. as a spindle I use this and the speed adjustment I prefer to manage with the spindle switch itself. I almost always set it t...

hi guys, I find this problem and I would like to know if it happens to you too. during milling work the machine is subject to strong and continuous vibrations which in the long run, but not too much, loosen the nuts of the structures that support the y and x and z axes. Is there a way to limit these...

I solved the problem by lowering the amperage of the drivers from 2.8 to 2.0. I noticed that this also reduced the noise generated by the engines that was really strong before.

Yes I can do it

The axis moves correctly when the motor is not in operation and moves correctly even when I switch on the machine and for part of the work. Suddenly it stops and no longer moves while the y axis continues normally. The engine of the x-axis during the block emits a very slight sound like a rustling s...

hi guys i built my rs cnc32 and i'm testing it by cutting 18mm fir pieces with a 12mm cutter. I am trying to exploit the whole floor both in length and in width. I have a problem though. at some point in the work, the x-axis motor stops. the y axis and the z axis work correctly but the x axis does n...

guys, I ask you for help, I can't connect my rs cnc to universal gcode sander. I connect the cnc usb to the pc I turn on the cnc and open the program, connect with the com port to baud 115200 but the following word appears in the console section: ets Jun 8 2016 00:22:57 rst: 0x1 (POWERON_RESET), boo...

these profiles cost too much. Has anyone found it cheaper?
Thank you