MakerFr.com

The alarms are still there as in the photos and I have to manually unclick them

I had $1=255, I set $1=0 and now after turning on the stepp engines are turned off

Ok, sorry, I mixed up threads, this is thread 1/1.5, can it be moved?

Hey,
Yes I used GRBL board V2.0.

Did you make any change in GRBL configuration ?
No

Did you use a software to connect a PC to GRBL lately ?
Yes, but nothing change

The nunchuk is connected and after manual unlocking it works normally.
Clean software 2.1 is installed, without any changes.
I don't really know how to check the "?" command. Can you explain what to do, I'm not an IT specialist.

1.I get this error every time I run it. Unlocking it requires moving the axis forward/back three times and then the padlock unlocks it. What could it be? I didn't have this in firmware 1, now in 2.1 every time. 2. In firmware 1, after starting the engines were not blocked, the head could be moved. U...

Hi kulfon250wr , For your information, I received the ESP-32E module from ESPRESSIF, today. Like the previous release (the ESP-32D module) from the brand, it doesn't boot alone when I plug it onto the Grbl board v.2.0 of Romain. Every times I power on the Grbl board v.2.0, I need to press its RESET...

And everything is clear, you are great

Me? I am not from MakerFr. I am a simple DIY maker exactly like you. I am moderator on the forum of MakerFr only because Romain (RoMaker) saw I was trying to help other DIY makers, here, and because I designed the RS-CNC32 assembly manual. See ya, I see, then I am very grateful for your help. But I...

Do I understand correctly, I'm not an IT specialist, that with this new method there is no need to upload the TFT software separately? No. This easier method is only for flashing the ESP-32 containing the firmware of Grbl_Esp32. If you want to easier flash the TFT firmware in the other ESP-32, use ...