MakerFr.com

Thanks. That worked.

thanks i will give it a go

Wow this is difficult I followed the instructions. Using Attolic True Studio. I open config.h and remove the # from the #define INVERT_SPINDLE_PWM command I then rebuild the project and it generates 2 errors expected '=', ',', ';', 'asm' or '__attribute__' before 'uint8_t' in nuts_bolts.h and unknow...

Hello again.
I've looked at the GRBL using Antonio and am completely confused.
Can you give me an idea as to what I should be looking for.
Where I should find it and
What I should change it to.
Any help is appreciated. I think my brain may be too old for this steep learning curve
Thanks

Thanks. I will have a look.. im not sure how to invert the PWM . Hopefully it may become clear when I take a look tomorrow
Thanks

Hello. I don't know if I'm in the correct place on this forum but I need help with the laser on my RCNC32 I've mounted at 15 watt laser and connected it to the board. Following the instructions on the firmware section. The laser works but in the negative.. When I switch on it immediately lights up a...

Yes it was a dry joint on the board
Thanks for solving my problem

Thank you. I will try all those things
Your help is appreciated

Thank you . Well I checked that and sure enough. There was a connection issue. Right pins but a bad connection. I now get the idle message and have better speeds. Also the numchuck now works. However I still have these problems No Z+ rotation. I have swapped the steppers around and eliminated any st...

Hello. I hope someone can help me. I've made 3 RCNC 32 for use in our lock down SHAREDWORKS community. Mechanically all looks good but we can't get the firmware to work properly. On power up we get buttons on the touch screen which seem to drive the steppers but very slowly X and Y axis steppers rot...