MakerFr.com

This is how I have it put, on the other hand when I cut a circle or a square the Y axis does not move, I am investigating why it moves when it is something more complex than a square or a circle. Greetings

can someone tell me why the acceleration is so low if it is normal and how could I fix it? If I put the independent Y axis driver with another transformer, could it be solved? Thank you

After many tests I begin to see the light, the acceleration of the X axis I have it in 400, on the other hand in the Y axis I have had to lower it to 35, I do not know if this hurts something but it is the only way that I do not know move the Y axis.

Greetings

here you can better appreciate the displacements

Hello, I'm looking in the forum for a problem like mine and I can't find it, some axis moves and I can't find the reason, saying that the engines after 10 minutes of work I can't touch them because of how hot they get. any lighting? greetings nema 23 2.8a engines configured in the drivers with their...

I have the Kress spindle


https://www.stoneycnc.com/amb-kress-105 ... 0vac/a3711

I have a question, should I remove the resistance to use the spindle?

I followed your steps but the laser did not react, I rewired the entire board to see if the fault was there but the laser was still the same. in the end I read a lot on the forum and decided to put a resistance between the S and 5v and I was happy to see that the laser was working correctly. now to ...

if you check it and it is fine, line 280 is as you say. # define_invert_pwm in front I don't have // ​​see you later

Hello, it is module 10w

https://a.aliexpress.com/_vMkG5D