5 résultats trouvés
- 24 déc. 2020 21:41
- Forum : R-CNC Adjustments
- Sujet : Z-Axis loosing height
- Réponses : 7
- Vues : 4214
Re: Z-Axis loosing height
Hi Gilles, Thanks to your suggestions I finally found the source of the problem. I measured the resistance of the motor coils. That showed the motor was OK. And then I noticed the grey wire had a very poor connection to the driver. So I reconnected everything properly and my machine works again. I a...
- 21 déc. 2020 20:39
- Forum : R-CNC Adjustments
- Sujet : Z-Axis loosing height
- Réponses : 7
- Vues : 4214
Re: Z-Axis loosing height
Hi Gilles, So I took the Z assembly apart to check all tolerances and tighten the bolts with thread lock. After re-assembly I started testing the movement. Manual movement is (as far as I know) is normal. Then I noticed the problem is probably not mechanical. My Z-motor has difficulty starting and m...
- 13 déc. 2020 15:49
- Forum : R-CNC Adjustments
- Sujet : Z-Axis loosing height
- Réponses : 7
- Vues : 4214
Re: Z-Axis loosing height
Hi HTeatre, Thank you for your quick and useful reply. I wasn't aware of this brilliant manual, as I build my machine sometime ago. Until now it worked well, but clearly all the vibrations have had their effect. Step 31 and 32 tell it all. I will get the thread lock tomorrow tighten the screw and se...
- 13 déc. 2020 12:27
- Forum : R-CNC Adjustments
- Sujet : Z-Axis loosing height
- Réponses : 7
- Vues : 4214
Z-Axis loosing height
My Z -axis sometimes looses height during the milling process, so in the end my spindle gets stuck and the machine cannot move anymore. I suspect it is the adjustement of the black part here: https://www.makerfr.com/wp-content/uploads/2018/07/tutorscnc-41.jpg. Can anyone explain how it works and how...
- 26 févr. 2020 17:47
- Forum : GRBL32bits V1.0/1.5
- Sujet : Card Mount Failed
- Réponses : 9
- Vues : 6137
Re: Card Mount Failed
Hi Steve,
I had the same problem. I found out it was not the SD Card, but the slot in the TFT that did not work correctly. After putting in an other TFT all works fine.
Regards,
Laurens
I had the same problem. I found out it was not the SD Card, but the slot in the TFT that did not work correctly. After putting in an other TFT all works fine.
Regards,
Laurens