MakerFr.com

Hello

Is this is ok?.. on picture are 3 conectors, i have only 2

Hello It looks like ESP32 can't connect to the COM port. How do I even know which COM port is right - via USB? And how to install the right driver for COM port. I bought a new ESP 32 but it's the same Arduino: 1.8.12 (Windows 7), Board: "ESP32 Dev Module, Disabled, Default, 240MHz (WiFi/BT), QI...

Hello thanks.. im load proper version, but now I get this error: Arduino: 1.8.12 (Windows 7), Board: "ESP32 Dev Module, Disabled, Default, 240MHz (WiFi/BT), QIO, 80MHz, 4MB (32Mb), 921600, None" Sketch uses 890966 bytes (67%) of program storage space. Maximum is 1310720 bytes. Global varia...

Hello What im doing wrong... to get this erroor Arduino: 1.8.12 (Windows 7), Board: "ESP32 Dev Module, Disabled, Default 4MB with spiffs (1.2MB APP/1.5MB SPIFFS), 240MHz (WiFi/BT), QIO, 80MHz, 4MB (32Mb), 921600, None" menu_file.cpp:53:1: error: 'File' does not name a type File fileToShow ...

hi

Im upload new firmware "without" nunchuk. I run with shield on and get what is in picture.. no response from spinndle relay..

hello I put together a RS CNC. loaded the TFT firmware and the screen works OK. I also loaded the firmware on the Arduino and it went OK too. when i plug in everything as instructed it doesn't work. I have already replaced Mega2560 but it still does not work. Since I have no end switches, I installe...

I will try, and post how work

Hello

I think that X pulleys and X motor at RS-CNC is very good solution. My question is, if possible modified "old" R-CNC with this two part.

Thanks for answer..

Best regards
Sebastjan

Thanks for info... Is there any instructions for "dummies" how install repetier firmware instead mailin?

Hello

Im noticed that piece are sligtly bigger then I draw. Example : 10x40 mm is milled about 10,9x 40,9mm. I also notice that small holes are square 2 mm size. I use 1 mm milling bit and corel drav to convert to DXF and thene ESTLCAM.

Thanks for some tip..